Check the position of the side print heads

WHAT YOU NEED 

Tools:Tape MeasureAllen key Set

Safety Equipment:Standard Personal Protective Equipment

CAUTIONWhen using the manual mode, make sure that everything and everyone is clear of moving parts to prevent damage or injuries.

1. Make sure the saw is homed.
2. Using the Manual Mode window, feed a long straight board into the saw and move it towards the printer until the end of the board is past the side print heads.
3. Check that the gap between the side print heads and the board is between 3 and 5 mm.

4. If required, adjust the position of the side print heads as follows:

   1. Press the E‑stop button on the operator console.
   2. Remove the printer guard by removing the screws that hold it to the printer backing plate.
   3. Loosen the four bolts that hold the print head bracket to the linear bearing.
   4. Move the side print heads to the correct position.
   5. Re-tighten the four mounting bolts.
   6. Re-check the position and re-adjust if required.
   7. Refit the printer guard.
5. Make sure the side print heads are secure and cannot twist.